PAM Configuration and Management Manual

SCF for PAM
PAM Configuration and Management Manual—523349-003
3-45
STATUS Command
STATUS Command
The STATUS command is a nonsensitive command that displays the dynamic state,
last error, and modifiable characteristics of the specified object. STATUS also displays
specific PAM subsystem attributes and values.
STATUS LINE Command
The STATUS LINE command shows the status of a line, including the state, name, and
primary and backup processors.
Command Syntax
OUT file-spec
directs any SCF output generated for this command to the specified file.
LINE line-name
is the name of the line.
SUB [ ALL | NONE | ONLY ]
directs the command at a set of subordinate objects.
ONLY specifies that only the subordinate objects are affected.
ALL specifies that the named object and the subordinate objects are affected.
NONE specifies that none of the subordinate objects are affected.
SEL [NOT] state
directs the command only to objects in the specified state or only to those not in
the specified state. Valid states are STARTED, STARTING, STOPPED,
STOPPING, and SUSPENDED.
DETAIL
causes the STATUS command to display a list of detailed information about the
status of the LINE object.
Consideration
There are no considerations for the STATUS LINE command.
STATUS [ /OUT file-spec/ ] LINE line-name
[, SUB [ ALL | NONE | ONLY ] ] [ , SEL [ NOT ] state ]
[ , DETAIL ]