PAM Configuration and Management Manual

SCF for PAM
PAM Configuration and Management Manual—523349-003
3-56
STOP Command
Reset Done
indicates that the reset procedure initiated from the local LS is accepted by the
remote LS and the reset is complete. The LS has returned to normal data transfer
state. All pending outbound frames are intact, and all inbound frames start to flow.
STATUS_CODE_MOD: none.
Reset Failure
indicates that the local LS has failed to complete the reset procedure because of
no response or a bad response from the remote LS. The LS has entered the disc
state. A CLOSE_LS command should be issued. STATUS_CODE_MOD: none.
STOP Command
The STOP command terminates the activity of PAM objects and changes the summary
state of the objects from STARTED to STOPPED. Any activity currently in progress is
terminated in an orderly manner. Subordinate objects, if any, must already be in the
stopped summary state.
STOP LINE Command
The STOP LINE command halts the operation of the specified LINE object and
disables access to the associated LIF.
Command Syntax
OUT file-spec
directs any SCF output generated for this command to the specified file.
LINE line-name
is the name of the line.
SUB [ ALL | NONE | ONLY ]
directs the command at a set of subordinate objects.
ALL specifies that the named object and the subordinate objects are affected.
NONE specifies that none of the subordinate objects are affected.
ONLY specifies that only the subordinate objects are affected.
STOP [ /OUT file-spec/ ] LINE line-name
[ , SUB [ ALL | NONE | ONLY ] ] [ , SEL [ NOT ] state ]