PAM Configuration and Management Manual

SCF for PAM
PAM Configuration and Management Manual—523349-003
3-57
STOP MSAP Command
SEL [NOT] state
directs the command only to objects in the specified state or only to those not in
the specified state. Valid states are STARTED, STARTING, STOPPED,
STOPPING, and SUSPENDED.
Consideration
There are no considerations for this command.
Example
This example stops the line named $PAMA:
STOP LINE $PAMA
STOP MSAP Command
The STOP MSAP command halts the operation of the specified MSAP object.
Command Syntax
OUT file-spec
directs any SCF output generated for this command to the specified file.
MSAP msap-name
is the name of the MSAP. The only valid MSAP name is #SNATR.
SUB [ ALL | NONE | ONLY ]
directs the command at a set of subordinate objects.
ALL specifies that the named object and the subordinate objects are affected.
NONE specifies that none of the subordinate objects are affected.
ONLY specifies that only the subordinate objects are affected.
SEL [NOT] state
directs the command only to objects in the specified state or only to those not in
the specified state. Valid states are STARTED, STARTING, STOPPED,
STOPPING, and SUSPENDED.
STOP [ /OUT file-spec/ ] MSAP msap-name
[ , SUB [ ALL | NONE | ONLY ] ] [ , SEL [ NOT ] state ]