PAM Management Programming Manual

Commands and Responses
PAM Management Programming Manual—142481
5-63
STATUS SESSION Command
ZPAM-SESS-ID
a unique ID used by the PAM subsystem for this session.
ZRMT-MAC-ADDR
specifies the MAC address of the remote session.
ZRMT-SAP-ADDR
specifies the SAP value of the remote session.
ZPT-LOST-LINK-NO-ACK
specifies that the LS has entered the reset state because of an exhausted retry count.
A SABME command has been sent to the remote LS.
ZRPT-LOST-LINK-RMT-BUSY
specifies that the LS has entered the reset state because of an exhausted retry count
while receiving RNR frames. A SABME command has been sent to the Remote LS.
A CLOSE_LS command should be issued.
ZRPT-LOST-LINK-REJ-FAIL
specifies that the LS has entered the reset state because of a failed reject. A SABME
command has been sent to the remote LS.
ZRPT-DISC
specifies that the LS has entered the DISC state from a received DISC command
frame. The STATUS_MODIFIER indicates whether frames were discarded. This
indicates an attempt to terminate the connection by the remote LS. A CLOSE_LS
command should be issued. STATUS_CODE_MOD: DATA_LOST or
NO_DATALOST.
ZRPT-DM
specifies that the LS has entered the disc state from a received DM response frame.
The STATUS_MODIFIER indicates whether frames were discarded. This indicates
an attempt to terminate the connection by the remote LS. A CLOSE_LS command
should be issued. STATUS_CODE_MOD: DATA-LOST or NO_DATALOST.
ZRPT-FRM-REJ-RCVD
specifies that the LS has entered the reset state because of a FRMR error. All
pending outbound frames are intact and all inbound frames are forwarded up to
SNAX. A CLOSE_LS command may be issued. STATUS_CODE_MOD: None.