PAM Management Programming Manual

Commands and Responses
PAM Management Programming Manual—142481
5-64
STATUS SESSION Command
ZRPT-SABME-FRM-RCVD
specifies that the LS has received a SABME frame. Prior to link connect, this
notification implies a connect request from the remote station; otherwise, it implies
link reset. A CLOSE_LS command may be issued. STATUS_CODE_MOD: None.
ZRPT-RESET
specifies that the reset procedure initiated from the local link station is accepted by
the remote LS and the reset is complete. The LS has returned to normal data transfer
state. All pending outbound frames are intact and all inbound frames start to flow.
ZRPT-RESET-FAIL
specifies that the local LS has failed to complete the reset procedure because of no
response or bad response from the remote LS. The LS has entered the disc state.
A CLOSE_LS command should be issued. STATUS_CODE_MOD: None.
ZACK-EXPD-TIMER
specifies how long a session waits for an acknowledgment from the remote session
of a frame sent. The default value is 2 seconds.
ZACK-SEND-TIMER
specifies how long the session waits before sending an acknowledgment to the
remote session of a frame received. The default value is 1.5 seconds.
ZINACTIVE-TIMER
specifies how long the session must be idle before this session contacts the remote
session to ensure the link is still intact. The default value is 10 seconds.
ZIFRM-XMIT-WIN
specifies how many unacknowledged transmitted frames may be outstanding at one
time. The default value is 7.
ZIFRM-RECV-WIN
specifies how many unacknowledged transmitted frames may be received before an
acknowledgment must be sent. The default value is 7.
ZMAX-RETRY-CNT
specifies the maximum number of times an I or S frame will be transmitted. The
default value is 5.
ZMAX-INFO-FIELD-LEN
specifies the maximum information field length that can be received by this session.
The default value is 1024.