PAM Management Programming Manual

Commands and Responses
PAM Management Programming Manual—142481
5-73
TRACE LINE Command
TRACE LINE Command
The TRACE LINE command returns trace information for a specified line. Items that
can be selected for line tracing in the ZCOM-TKN-TRACE-OPT token are
Tokens in Response Buffer
The tokens present in the buffer received in response to the TRACE command are
described in Section 4, Common Definitions.
Operational Notes
There are several things you should remember when using the TRACE command:
•
A backup trace cannot be started unless a primary trace is already active. The same
traces must be selected for a backup trace as those selected for the primary trace.
•
When backup tracing is not selected, a trace will stop if the subsystem switches to
the backup processor.
•
You can use the ZCOM-TKN-SEL-SUMSTATE token to include or exclude objects
from the TRACE command based on their current summary state. The only valid
value for this token is ZCOM-VAL-SUMSTATE-STARTED.
ZPAM-VAL-PAM-COMMON
Traces the PAM common events
ZPAM-VAL-PAM-LIF
Traces LIF events
ZPAM-VAL-PAM-LIF-DI
Traces LIF data in
ZPAM-VAL-PAM-LIF-DO
Traces LIF data out
ZPAM-VAL-PAM-MSG
Traces PAM messages
ZPAM-VAL-PAM-OPENER
Traces PAM opener information
ZPAM-VAL-PAM-MEMORY
Traces PAM memory management
ZPAM-VAL-PAM-CONFIG
Traces PAM #CONFIG events
ZPAM-VAL-PAM-PORT
Traces PORT events
ZPAM-VAL-PAM-SNATR
Traces SNATR events