PAM Management Programming Manual

Event Messages
PAM Management Programming Manual—142481
6-29
208: ZPAM-EVT-IO-PROC-ABENDED
ZPAM-VAL-ABEND-CONFIG-BRO-INV
The backup processor specified while starting PAM was either out of range or
the same as the primary processor. Restart PAM with the correct backup
processor value.
ZPAM-VAL-ABEND-CONFIG-LIF-INV
The LIF name was incorrectly specified while starting up PAM. Restart PAM
with the correct LIF name.
ZPAM-VAL-ABEND-CONFIG-MAX-INV
The maximum request size was incorrectly specified while starting up PAM.
The valid range is 128-32000. Restart the PAM process with the correct
maximum request size.
ZPAM-VAL-ABEND-CONFIG-QUE-INV
The maximum queue depth was incorrectly specified while starting up PAM.
The valid range is 256-4096. Restart PAM with the correct maximum queue
depth.
ZPAM-VAL-ABEND-INIT-CHKPT-ERR
The initial checkpoint could not be done to the backup.
Probable Cause
The PAM process detected an error at process initialization time and is unable to go on.
Recommended Action
Except where noted above in the individual events, follow the procedures below.
If the process still fails, contact your service provider and provide all relevant
information as follows:
•
Descriptions of the problem and accompanying symptoms
•
Details from the message or messages generated
•
Supporting documentation such as Event Management Service (EMS) logs, trace
files, and a processor dump, if applicable
If your local operating procedures require contacting the Global Customer Support
Center, supply your system number and the numbers and versions of all related products
as well.