PAM Management Programming Manual

Event Messages
PAM Management Programming Manual—142481
6-34
210: ZPAM-EVT-PORT-CONFIG-FAILED
ZEMS-TKN-CONSOLE-PRINT
directs the compatibility distributor to process the event message
(ZSPI-VAL-TRUE).
ZEMS-TKN-CPU
is the processor number of the reporting subsystem process.
ZEMS-TKN-CRTPID
is the CRTPID of the reporting subsystem process.
ZEMS-TKN-GENTIME
is the time (GMT) that the reporting subsystem created the event message.
ZEMS-TKN-LOGTIME
is the time (GMT) that the collector wrote the event message to its log files.
ZEMS-TKN-PIN
is the process ID number (PIN) of the reporting subsystem process.
ZEMS-TKN-SYSTEM
is the Expand system number of the system (node) on which the event was reported.
ZEMS-TKN-USERID
is the user ID of the reporting subsystem process.
ZPAM-TKN-SDN
is the subdevice number of the subdevice that is reporting a problem.
Probable Cause
PAM could not configure a port. This error should be preceded by a port configuration
error.
Recommended Action
Recovery depends on the type of problem. Issue the START command again.
If the problem persists, contact your service provider and provide all relevant
information as follows:
•
Descriptions of the problem and accompanying symptoms
•
Details from the message or messages generated
•
Supporting documentation such as Event Management Service (EMS) logs, trace
files, and a processor dump, if applicable