Pathmaker Reference Manual Installation Addendum

RESTDSV
Receive Software.
Create New Revision.
TOOL
Tool Assigns. Run only as instructed by Support Personnel; this is not
a regular task.
DOCPRINT
Prepare Softdocs.
Prepare Release Docs.
SYSGEN Build.
RESTSYS Apply.
REPLACEBOOT No equivalent. Use SCF.
REPSUBSYS Apply.
System Load (if needed).
System Load (if needed)
ZPHIRNM (run before a system load).
Problem 2: DSM/SCM creates a target subvolume (TSV) instead of an ISV.
Solution: The concept of an ISV has simply been replaced by the concept of a TSV. The subvolume's default name and function
remain the same. To complete installation of the Pathmaker software, go to the appropriate TSV and run the PMINSTAL utility.
Where to Find More Information
The process of using DSM/SCM to install and update software differs a great deal from the process of using Install. The following table
indicates where in the DSM/SCM User's Guide you can find more information about these differences and about how to use
DSM/SCM.
For Information On Refer To
Differences between Install and DSM/SCM Section 3: DSM/SCM, Install, and DSM/SCM Updates
Overview of DSM/SCM
Section 1: Introduction to DSM/SCM
Section 2: DSM/SCM Interfaces and Tools
Receiving Software Section 8: Receiving and Managing Software Inputs
Creating Software Revisions Section 9: Creating Software Revisions
Building Software Section 10: Building and Applying a New Configuration
Applying Software Section 10: Building and Applying a New Configuration