Pathmaker Reference Manual

PMINSTAL Utility
Utilities
5–4 067869 Tandem Computers Incorporated
Table 5-1. Contents of PMDEFLT and Syntax for Changing Default Values (Page 2 of 6)
Contents of PMDEFLT Comments
EnformSubvol $SYSTEM.SYSTEM The syntax for changing the default Enform subvolume is:
EnformSubvol $volume.subvolume
where $volume is the name of an existing disk volume and
subvolume is a valid Guardian 90 subvolume name. You
cannot specify a system name.
Whenever you change the Enform program subvolume, you
must also change the Enform process definition to refer to
the same subvolume.
-- The paragraphs below define the programs that can be run
-- from a project’s Pathmaker user interface. Edit the
-- attributes to specify desired priorities, CPUs, and swap
-- volumes. Note that Pathmaker ignores CPUs which are not
-- configured and running when the program is invoked.
-- Programs which have no program file name specified are
-- supplied with Pathmaker, and reside in the subvolume where
-- Pathmaker is installed. PMINSTAL automatically determines
-- the correct program file location for these programs.
ProcessName COBOL
The syntax for changing the default process name is:
ProcessName identifier
where identifier is the logical name of the process. The
logical name must be one of the following:
COBOL SCOBOL
DDL SCUP
EDIT SQLCI
ENFORM SQLCOBOL
FUP SQLCOMP
PERUSE
ProcessProgramFile $SYSTEM.SYSTEM.COBOL85 The syntax for changing the default process program file
name is:
ProcessProgramFile [\system.] $vol.subvol.file
where \system.$vol.subvol.file specifies the disk volume,
subvolume and file name of the physical program object file.
If you omit the system name, PMINSTAL assumes the object
file is on the current system.