Pathmaker Reference Manual

PMPROJECT Utility
Utilities
067869 Tandem Computers Incorporated 5–19
Project PATHMON process name
Enter a PATHMON process name. The format is $xyyyy —where x is an alpha
character and yyyy are optional alphanumeric characters. If you use the
name across the network, its maximum length is five—a dollar sign and four
alphanumeric characters.
Project PATHMON CPUs
Enter a primary and backup CPU for the project’s PATHMON process. The
syntax is:
primary [ : backup ]
If your project uses a CLX system, you need specify only one CPU. After you
specify CPUs, PMPROJECT prompts you to list the CPUs on which project
servers and TCPs will run.
TCP and server swap volume
Specify a disk volume on the same system as the Pathmaker installation, or
press RETURN for the default project swap volume. The default is the volume
on which Pathmaker is installed.
Number of TCPs in the project
Enter the number of terminal control processes (TCPs) available in the
project's Pathway system or press RETURN to specify the default (1). Allow
one TCP for every 20 concurrent users of a project.
Project execution priority
Enter a value between 3 and 189 to specify a fixed execution priority, or press
RETURN for the default. The default specifies that the $CMON process on the
system where the project is defined determines the priority dynamically, when
the project is started.
Project execution security
Default is N. For file security information, refer to the FUP SECURE
command in the File Utility Program (FUP) Reference Manual.
Project home terminal
Enter the name of the terminal the project will use to report messages. The
name should not the be same as the terminal where the application is run.
Default is $RTC.
Project PATHMON log file
Enter the file name for the log of PATHMON activities. Default is
$vol.subvol.T9154LOG.