Pathway/iTS 1.0 README for S Systems

Note: Compaq recommends that you move/copy the files by using
either DSM/SCM or IPSetup for each distribution CD in
the Pathway/iTS product set (iTS Gateway components,
the SCOBOL Java Package, the Connection Router, and
Client Object Manager) to place all the files on the
NonStop(TM) Kernel system.
7. Follow the post-installation instructions in Section III below,
if any, after using IPSetup to place and install this product.
II. Pre-Installation Instructions
1. Ensure that you, the installation user, are not listed in
$SYSTEM.ZTCPIP.FTPUSERS.
Discussion: If you try to install products using IPSetup and
your user ID is listed in $SYSTEM.ZTCPIP.FTPUSERS, the
installation fails at the point where IPSetup tries to transfer
(ftp command) the files from the PC to the NonStop(TM) Kernel
system. This failure occurs in a typical situation when you
install the product using the super.super ID and, for common
security reasons, the super.super ID is forbidden ftp access.
2. If when you use IPSetup, IPSetup fails with error 550 indicating
it was unable to do a "chdir" to the subvolume specified, ensure
that you use a userID that does not have an initial OSS
directory.
Discussion: IPSetup assumes ftp is using the Guardian API.
If the user ID specified to IPSetup has an initial OSS directory
(that is, the SAFEGUARD attribute initial-directory is set) then
ftp uses the OSS API and IPSetup fails with error 550 indicating
it was unable to do a "chdir" to the subvolume specified. To work
around this problem, alter the user ID by resetting the attribute
initial-directory and rerun IPSetup.
To reset the initial-directory attribute, type the following
command at the TACL prompt:
TACL> SAFECOM
+ ALTER USER <userid>, INITIAL-DIRECTORY
+ EXIT
III. Post-Installation Instructions
1. In $SYSTEM.ZPITS subvolume, execute the following command at
the TACL prompt for installation of the License files:
RUN ZLICPAK
After the execution of this command, you should have ZLICSA58
and ZLICSA59 license files in the $SYSTEM.ZPITS subvolume.
2. Copy these two license files: ZLICSA58 and ZLICSA59, from
$SYSTEM.ZPITS to $SYSTEM.ZPATHWAY subvolume. Purge any older
versions of these files in $SYSTEM.ZPATHWAY subvolume.
These files in the ZPATHWAY subvolume must be installed and
retained on $SYSTEM for NonStop(TM) TS/MP and Pathway/iTS to
work correctly.
file:///C|/READMEs PATHWAY/PathwayiTS 1.0/ReadmePwyiTS15Ssystems.txt
file:///C|/READMEs PATHWAY/PathwayiTS 1.0/ReadmePwyiTS15Ssystems.txt (2 of 9) [4/27/2004 11:11:25 AM]