Pathway/iTS Management Programming Manual

TCP Event Messages
NonStop Pathway/iTS Management Programming Manual—426749-002
11-288
ZEMS-TKN-SUBJECT-MARK
indicates either ZPWY-TKN-TERMNAME or ZPWY-TKN-TCPNAME, which
contains the name of the TERM or TCP that is the subject of this event message.
If the subject token is ZPWY-TKN-TERMNAME, then
ZPWY-TKN-INSTRUCTION, ZPWY-TKN-PUNAME, ZPWY-TKN-PUOFFSET,
ZPWY-TKN-PUVERSION, and ZPWY-TKN-TCLPROGFNAME are included;
otherwise, these tokens are omitted.
ZPWY-TKN-EVENTCLASS
has the value ZPWY-VAL-ERROREVENT.
ZPWY-TKN-UNSOLREJECTEDERROR
contains an error number indicating why an unsolicited message was rejected. N
indicates that this token can occur in a nested message.
ZPWY-TKN-INSTRUCTION, ZPWY-TKN-PUNAME, ZPWY-TKN-PUOFFSET,
ZPWY-TKN-PUVERSION, and ZPWY-TKN-TCLPROGFNAME
are conditional tokens specific to this event message; these tokens are included
only if the subject token is ZPWY-TKN-TERMNAME. For descriptions of these
tokens, see the TS/MP Management Programming Manual.
Effect. The TCP rejects the unsolicited message and replies to the sender without
delivering it to the target requester.
Recovery. Recovery depends on the type of the error that occurred. errnum can be
one of the following:
0 No error.
1 A file-system error occurred.
2 Target terminal is suspended.
3 Target terminal queue is full. (The TERM MAXINPUTMSGS configuration value
has been exceeded.)
4 Target TCP queue area is full.
5 Target queueing is not enabled. (The TCP MAXINPUTMSGS configuration
value is set to 0.)
6 Length field in the message exceeds the configured maximum for the TCP.
7 There was an unrecognizable request code (refers to MSG-ID and MSG-
VERSION fields).
8 Named terminal is not found.