Pathway/iTS SCUP Reference Manual

SCUP Commands
HP NonStop Pathway/iTS SCUP Reference Manual—520269-002
2-35
OBEYSYS Command
the original input file for SCUP was a terminal, the terminal is issued a prompt. If the
input file was not a terminal, SCUP terminates.
The following are examples of the OBEY command:
OBEY abc.scupcmd
OBEY scupcmd
OBEYSYS Command
The OBEYSYS command sets the default system for expansion of obey file names.
system
is a Guardian node name.
If the OBEYSYS command is not issued, the default settings in effect when SCUP was
started are used. If the node name is omitted, the default is set for local file-name
expansion. Note that this is not the same as specifying the local system name.
Omitting the node name in this command permits references to long device names;
long device names are prohibited in network-form file names.
If the specified node name is invalid, or would be invalid when combined with the
current OBEYVOL setting, an error occurs. An error message is displayed and the
OBEYSYS setting is not changed.
The following are examples of the OBEYSYS command:
OBEYSYS \ny
OBEYSYS \sd
OBEYVOL Command
The OBEYVOL command sets the default volume and subvolume for expansion of
obey file names.
volume
is a Guardian volume name.
subvol
is a Guardian subvolume name.
If the OBEYVOL command is not issued, the default settings in effect when SCUP was
started are used. If either the volume name or subvolume name is omitted, the
OBEYSYS [ \system ]
OBEYVOL [ $volume ]
[ [ $volume. ] subvol ]