Pathway/iTS SCUP Reference Manual

SCUP Messages
HP NonStop Pathway/iTS SCUP Reference Manual—520269-002
A-4
General SCUP Messages
Recovery. Change one of the file names.
Cause. A file-system or sequential I/O procedure error (identified by message and
errnum) occurred during operation of the command.
Effect. The command fails.
Recovery. Refer to the description of the file-system error in the Guardian Procedure
Errors and Messages Manual and take corrective action as specified.
Cause. An invalid file name (identified by file-name) was entered and a file-system
error (identified by errnum) occurred.
Effect. The command fails.
Recovery. Check the file name for accuracy and correct the name as needed. If you
need further information, refer to the description of the file-system error in the Guardian
Procedure Errors and Messages Manual.
Cause. The file specified by file-name could not be opened because of a file-
system error (identified by message and errnum).
Effect. For commands other than CONVERT, the command fails. For the CONVERT
command, either conversion fails for that program unit or the entire conversion fails,
depending on the error.
Recovery. Refer to the description of the file-system error in the Guardian Procedure
Errors and Messages Manual and take corrective action as specified. If the error is
“nonexistent file (11)”, verify the existence of the file in the current volume and
subvolume and reenter the command.
Cause. An invalid subvolume name was entered.
Effect. The command fails.
Recovery. Check the subvolume portion of the specified file name for a accuracy and
correct it as needed.
FILE ERROR - file-name - message (errnum)
FILE NAME ERROR - file-name (errnum)
FILE OPEN ERROR file-name - message (errnum)
SUBVOLUME NAME ERROR