Pathway/iTS SCUP Reference Manual

SCUP Messages
HP NonStop Pathway/iTS SCUP Reference Manual—520269-002
A-7
Converter Messages
If your local operating procedures require contacting the HP Global Customer Support
Center (GCSC), supply your NonStop system number and the numbers and versions
of all related products as well.
Cause. A prior attempt was made to convert the application by specifying the same
INITPROG parameter but with a different APPNAME parameter.
Effect. The conversion process stops.
Recovery. Reissue the command with the correct APPNAME parameter. If you want
to convert the application using the new APPNAME value, delete the MAP file and all
the files in the HTMLVOL and JAVAVOL volumes that correspond to the application.
Then restart the conversion. The MAP file is created in the location where the
CONVERT command is issued.
Cause. Either the configuration file name is invalid or the converter was unable to
locate the specified configuration file.
Effect. The conversion fails.
Recovery. Check whether the config-file name is valid; if not, correct it. If the
config-file name is valid, make sure it is located in the specified location. Then
restart the conversion.
Cause. The converter exceeded the predefined limits for the specified parameter.
Effect. The converter skips the program unit and continues to convert the remaining
program units.
Recovery. In the Limits Section of the configuration file, specify a value for the limit
parameter (limit-param) that is greater than actual-num. Restart the conversion.
Cause. The converter could not create the specified MAP file because of the file-
system error indicated.
Error - APPNAME app-name mismatch. A prior version of the converted
software exists with a different value for the APPNAME parameter.
Error - Configuration file not found config-file
Error - Configured limit violation for (limit-param) : Actual (actual-num)
Allowed (allowed-num)
Error - Creation error for MAP file map-file-name (errnum)