Pathway/iTS SCUP Reference Manual

SCUP Messages
HP NonStop Pathway/iTS SCUP Reference Manual—520269-002
A-13
Converter Messages
Cause. A file-system error or sequential I/O error (identified by errnum) occurred
while the converter was writing the HTML source file specified by html-file-name.
Effect. The conversion fails for that program unit.
Recovery. Refer to the description of the file-system error or sequental I/O error in the
Guardian Procedure Errors and Messages Manual and take corrective action as
specified. Then restart the conversion. If no corrective action is possible, contact your
service provider.
Cause. The user is not authorized to run the CONVERT command.
Effect. The CONVERT command fails.
Recovery. Contact the HP Professional Services group to get your application
converted or contact your HP representative to get authorization.
Cause. The converter was unable to locate the specified program ID in the INITPROG
parameter in the currently opened file, identified by file-name.
Effect. The conversion continues after generating the warning. The application will fail
at run time if the program identified by the INITPROG parameter was not converted.
Recovery. Check whether the INITPROG parameter is valid; if it is invalid, correct it.
If the INITPROG parameter is valid, ensure that the program unit is in the POBJ file
specified by file-name. Then restart the conversion.
Cause. The converter traces the call sequence in the POBJ file starting with the
INITPROG. The converter displays this message if it was unable to locate one or more
program IDs in the specified POBJDIR file (dir-file-name). The displayed
message identifies the missing program IDs.
HTML file error for html-file-name (errnum)
This service is only available through Professional Services.
Contact your HP representative to enable the feature.
Warning - INITPROG program-id not found in file file-name
Warning - The following program units are not available in the current
file dir-file-name:
program-id
program-id
...