Pathway/iTS System Management Manual (G06.24+)

HP NonStop Pathway/iTS System Management Manual—426748-002

8-1

Pathway Environment Control

Commands

In general, the PATHCOM commands that control the PATHMON process and the

Pathway environment as a whole deal with objects managed by the TS/MP product or

with the global PATHWAY and PATHMON objects. These commands are described in

detail in the TS/MP System Management Manual. One of these commands, however—

the SET PATHWAY command—allows you to define attribute values for HP NonStop

Pathway/iTS objects in addition to the TS/MP objects. Other commands can impact

Pathway/iTS objects in various ways. This section describes those aspects of the SET

PATHWAY command that affect TCP, TERM, PROGRAM, and TELL objects, and

summarizes the effects of other commands upon these objects.

SET PATHWAY Command

Use the SET PATHWAY command to establish attribute values for the PATHWAY

object. Use this command for configuring the PATHMON process before you start a

PATHMON environment.

The following command description is limited to PATHWAY object attributes that are

specific to Pathway/iTS objects, such as TCP, TERM, and PROGRAM objects. For

information about using the SET PATHWAY command to establish values for

PATHWAY object attributes that affect objects managed by TS/MP, or for global

PATHMON and PATHWAY object attributes, see the TS/MP System Management

Manual.

pw-attribute

For information about configuration limits for environments, see Appendix C,

Configuration Limits and Defaults.

SET PATHWAY pw-attribute [ , pw-attribute ]...

pw-attribute is:

MAXTCPS number

MAXTERMS number

MAXEXTERNALTCPS number

MAXPROGRAMS number

MAXTELLQUEUE number

MAXTELLS number

MAXTMFRESTARTS number