Pathway/iTS System Management Manual (G06.24+)

Pathway Environment Control Commands
HP NonStop Pathway/iTS System Management Manual—426748-002
8-3
SET PATHWAY Command
number must be a value from 0 through 4095. If you omit this attribute, the default
is 0; temporary TERM objects cannot be started in the PATHMON environment
through the RUN PROGRAM command.
MAXTELLQUEUE number
is the maximum number of tell messages that can be queued for each terminal.
number must be a value from 0 through 300. If you omit this attribute, the default
is 4.
MAXTELLS number
is the maximum number of tell messages that can exist concurrently within a
PATHMON environment.
number must be a value from 0 through 4095. If you omit this attribute, the default
is 32.
MAXTMFRESTARTS number
is the maximum number of times a TCP attempts to restart a logical TMF
transaction after the transaction aborts and before the SEND error occurs. If this
limit is reached and the SCREEN COBOL BEGIN-TRANSACTION verb does not
have an ON ERROR clause, the terminal is suspended, but can be restarted.
number can be:
If you omit this attribute, the default is 5.
Consideration
All object attributes can be changed before a cold start.
1 through 32,767 Specifies the number of restarts
0 Specifies no restarts
-1 Specifies unlimited restarts
Note. The SET PATHWAY command can also be used to configure attribute values for
objects controlled through TS/MP, such as SERVER and LINKMON objects, in addition to
attributes for the global PATHWAY and PATHMON objects. Parameters used for these objects
include the following, all described in TS/MP System Management Manual: MAXASSIGNS,
MAXPARAMS, MAXSERVERCLASSES, MAXSERVERPROCESSES, MAXSTARTUPS,
MAXDEFINES, MAXLINKMONS, MAXPATHCOMS, MAXSPI, OWNER, and SECURITY.