Pathway/iTS System Management Manual (G06.24+)

HP NonStop Pathway/iTS System Management Manual—426748-002

9-1

Terminal Control Process (TCP)

Commands

This section describes the PATHCOM commands that define and control TCPs; the

commands are listed in alphabetical order. The TCP commands are as follows:

This commands configure and control TCPs. With these commands you can do the

following:

•

Set and modify TCP attributes

•

Add and delete TCPs

•

Start and stop TCPs

•

Display TCP attribute and status information

•

Control TCP operation

To Perform the Following Tasks… Use These PATHCOM Commands…

Define and remove TCPs SET TCP

ADD TCP

CONTROL TCP

DELETE TCP

Control TCPs START TCP

STOP TCP

Change TCP attributes ALTER TCP

RESET TCP

Obtain information about INFO TCP

SHOW TCP

STATS TCP

STATUS TCP

Perform other management tasks SWITCH TCP

PRIMARY TCP

REFRESH-CODE TCP

Note. This manual documents only TCPs for which the code is in the program file

$SYSTEM.SYSTEM.PATHTCP2. All references to TCP denote this file name.