Pathway/iTS System Management Manual (G06.24+)

Terminal Control Process (TCP) Commands

HP NonStop Pathway/iTS System Management Manual—426748-002

9-3

ALTER TCP Command

Use the ALTER TCP command to change the attribute values of a TCP that was

previously added to the PATHMON configuration file. The TCP must be stopped before

you can alter an attribute value. For a list of the TCP attributes, see the SET TCP

Command on page 9-18.

tcp-name

specifies the name of a previously defined and added TCP.

tcp-attribute

specifies an attribute describing a TCP object. A TCP attribute consists of a

keyword and a value. The value you enter overrides the value previously

established with the SET TCP command. Use any of the attributes listed for the

SET TCP command.

RESET

changes an existing attribute of a TCP to the default value.

If an attribute is not required and no default value exists, this option deletes the

value set for the attribute.

If an attribute is required and no default value exists, the RESET option generates

a syntax error and leaves the current attribute value unchanged.

ALTER [ TCP ] tcp-name

{ , tcp-attribute }

{ , RESET tcp-keyword }

{ , RESET ( tcp-keyword [, tcp-keyword ]... ) }

tcp-keyword is:

AUTORESTART INSPECT POWERONRECOVERY

CHECK–DIRECTORY MAXINPUTMSGLEN PRI

CODEAREALEN MAXINPUTMSGS PROCESS

CPUS MAXPATHWAYS PROGRAM

DEBUG MAXREPLY SERVERPOOL

DUMP MAXSERVERCLASSES SENDMSGTIMEOUT

GUARDIAN–LIB MAXSERVERPROCESSES STATS

GUARDIAN–SWAP MAXTERMDATA SWAP

HIGHPIN MAXTERMS TCLPROG

HOMETERM NONSTOP TERMBUF

TERMPOOL