Pathway/iTS System Management Manual (G06.24+)

Terminal Control Process (TCP) Commands
HP NonStop Pathway/iTS System Management Manual—426748-002
9-32
SHOW TCP Command
SHOW TCP Command
Use the SHOW TCP command to display a subset of the TCP attributes in alphabetic
order. This command displays the attribute values for a TCP not yet added to the
PATHMON configuration file.
OUT list-file
directs output to the named list file; this could be a DEFINE name. If this option is
omitted, the PATHMON process directs the output to the PATHCOM list file; this is
typically the home terminal.
Considerations
•
When PATHCOM first starts or after a RESET TCP command executes, the
SHOW TCP command displays only the required SET TCP attributes and a subset
of the optional attributes that have PATHMON defaults. A question mark appears
for the required attribute values that you must set before adding the TCP.
•
SHOW TCP displays all of the attribute values that you explicitly set with the SET
TCP command.
•
For attributes that include Guardian file names, SHOW TCP displays the
node-name part of the file name as either \nodename or \*. The \nodename form is
used if the node was explicitly specified by the user. The \* form is used if the
attribute was specified to default to the node where the PATHMON process is
running.
•
After an ADD TCP command, SHOW TCP continues to display the attribute values
held in PATHCOM for the previously added TCP. Use the RESET TCP command
to change all of the values to their defaults, or use the SET TCP command to
replace specific attribute values.
•
After a PATHCOM OPEN command, the SHOW TCP command displays the TCP
attribute values PATHCOM holds for the PATHMON environment controlled by the
PATHMON process you have opened. Use the SET TCP command to assign the
attribute values you require.
SHOW [ / OUT list-file / ] TCP