Pathway/iTS System Management Manual (G06.24+)

Terminal Control Process (TCP) Commands
HP NonStop Pathway/iTS System Management Manual—426748-002
9-36
STATS TCP Command
STATE state-type
specifies the state of the multiple TCPs. Possible values are:
PENDING NOT PENDING
RUNNING NOT RUNNING
STOPPED NOT STOPPED
This command displays statistics only for those TCPs in the RUNNING state. If you
specify any other state, the system redisplays the command prompt; it does not
display any output or generate an error message.
You can substitute SEL for STATE.
COUNT number
specifies the number of times that the STATS command repeats. You can stop the
command from repeating by pressing the Break key.
DETAIL
includes statistics such as response time information, for the terminals and server
classes associated with the specified TCP.
FREQTABLE
generates a frequency distribution table containing statistics for each terminal and
server class associated with the specified TCP.
The frequency distribution table is not generatedeven if you specify the
FREQTABLE optionunder these conditions:
•
There have been fewer than 50 response time measurements collected at the
time of the STATS request.
•
At the fiftieth measurement, the size of the time interval calculated is less than
0.01 second.
For more information about the FREQTABLE option, including a sample display,
see Section 5, Tuning Your System Using Statistics.
INTERVAL number
specifies the time period between the statistics displays, incremented in hours,
minutes, or seconds.
RESET
sets the counters used for the measurements back to zero.