Pathway/iTS System Management Manual (G06.24+)

Terminal Control Process (TCP) Commands
HP NonStop Pathway/iTS System Management Manual—426748-002
9-37
STATUS TCP Command
Considerations
•
If the SET TCP STATS attribute value is set to OFF, the TCP does not gather
information for this command.
•
When you use the DETAIL option, the TCP displays the terminals and server class
statistics described in Section 10, TERM Commands, and in the TS/MP System
Management Manual, respectively.
•
For more information about PATHMON environment statistics and the STATS TCP
command display, see Section 5, Tuning Your System Using Statistics, and the
TS/MP System Management Manual.
Examples
The following command displays the statistical information gathered for the three
named TCPs for a 10-minute interval:
STATS TCP-1, TCP-3, TCP-5, DETAIL, INTERVAL 10 MINS
The following commands direct statistical information, including measurements on
system responsiveness (as perceived by the user), to a specified file:
STATS /OUT STATFLE/ TCP-1, DETAIL, FREQTABLE, INTERVAL 2 HRS
STATS /OUT STATFLE/ TCP *, RESET, INTERVAL 30 MINS, COUNT 2
The following command displays statistical information for all TCPs in the RUNNING
state for a 10-minute interval:
STATS TCP *, STATE RUNNING, INTERVAL 10 MINS
STATUS TCP Command
Use the STATUS TCP command to display the status of a TCP and the terminals it
controls.
STATUS [ / OUT list-file / ]
{ [ TCP ] tcp-name [ , DETAIL ] }
{ [ TCP ] ( tcp-name [ , tcp-name ]... ) [ , DETAIL ] }
{ [ TCP ] E\node.$process-name [ , DETAIL ] }
{ TCP * [ , option [ , option ] ] }
option is:
STATE state-type
DETAIL