Pathway/iTS System Management Manual (G06.24+)

TERM Commands
HP NonStop Pathway/iTS System Management Manual—426748-002
10-5
ALTER TERM Command
ALTER TERM Command
Use the ALTER TERM command to change the attribute values of a TERM object that
was previously added to the PATHMON configuration file. For a list of the TERM
attributes, see the SET TERM Command on page 10-16.
The TERM object must be stopped before you can alter an attribute value.
This command can be issued only to configured TERM objects.
term-name
specifies the name of a previously defined and added TERM object.
term-attribute
specifies an attribute describing a TERM object. A TERM attribute consists of a
keyword and a value. The value you enter overrides the value previously
established with the SET TERM command. Use any of the attributes listed for the
SET TERM command.
RESET
changes an existing attribute of a TERM object to the default value.
If an attribute is not required and no default value exists, this option deletes the
value set for the attribute.
If an attribute is required and no default value exists, the RESET option generates
a syntax error and leaves the current attribute value unchanged.
term-keyword
specifies a single SET TERM command attribute keyword or several keywords
separated by commas and enclosed in parentheses.
ALTER [ TERM ] term-name
{ , term-attribute [ , term-attribute ]... }
{ , RESET term-keyword }
{ , RESET ( term-keyword [, term-keyword ]... ) }
term-keyword is:
AUTORESTART FILE TCLPROG
BREAK INITIAL TCP
DIAGNOSTIC INSPECT TMF
DISPLAY-PAGES IOPROTOCOL TRAILINGBLANKS
ECHO MAXINPUTMSGS TYPE
EXCLUSIVE PRINTER