Pathway/iTS System Management Manual (G06.24+)

TERM Commands
HP NonStop Pathway/iTS System Management Manual—426748-002
10-6
ALTER TERM Command
Consideration
If a TERM object is configured with the SET TERM INSPECT attribute set to ON and a
file name, the ALTER TERM RESET command sets the INSPECT attribute to OFF and
deletes the file name.
Errors
The following table lists the most common error that can occur during the processing of
the ALTER TERM command:
Examples
The following commands change various attribute values for the specified TERM
objects:
ALTER TERM TERM-1,TMF OFF
ALTER TERM TERM-2,INITIAL IMFMENU
ALTER TERM-3,RESET AUTORESTART
ALTER TERM-4, TCP TCP-4, RESET (DISPLAY-PAGES,TYPE,PRINTER)
This Message… Is Displayed When…
*1101* TOO MANY
TERM ENTRIES
You have tried to alter a TERM object but you have already added
the maximum number of TERM entries (that is, 4095) supported by
the PATHMON process.
The command failed because the PATHMON process executes the
ALTER TERM command by creating a new TERM entry with the
altered values before deleting the existing TERM entry. When the
maximum number of TERM entries already exists, the PATHMON
process does not have the space to create a new TERM .
To avoid this problem, define and add the maximum number of
TERM entries allowed minus 1 (that is, 4094 TERMs).