Pathway/iTS System Management Manual (G06.24+)

TERM Commands
HP NonStop Pathway/iTS System Management Manual—426748-002
10-26
SHOW TERM Command
SHOW TERM Command
Use the SHOW TERM command to display a subset of the TERM attributes in
alphabetic order. This command displays the attribute values for a TERM object not yet
added to the PATHMON configuration file.
This command can be issued only to configured TERM objects.
OUT list-file
directs output to the named list file; this could be a DEFINE name. If this option is
omitted, the PATHMON process directs the output to the PATHCOM list file; this is
typically the home terminal.
Considerations
•
When PATHCOM first starts and after a RESET TERM command executes, the
SHOW TERM command displays only the required SET TERM attributes and a
subset of the optional attributes that have default values. A question mark appears
for the required attribute values that you must set before adding the TERM object.
•
SHOW TERM displays all of the attribute values that you explicitly set with the SET
TERM command.
•
For attributes that include Guardian operating environment file names, SHOW
TERM displays the node-name part of the file name as either \nodename or \*. The
\nodename form is used if the node was explicitly specified by the user. The \*
form is used if the attribute was specified to default to the node where the
PATHMON process is running.
•
After an ADD TERM command, the SHOW TERM command continues to display
the attribute values held in PATHCOM for the previously added TERM object. Use
the RESET TERM command to change all of the values to their defaults, or use
the SET TERM command to replace specific attribute values.
Examples
If you issue the SHOW TERM command before setting the TERM object attributes, the
following information is displayed:
TERM
AUTORESTART 0
BREAK OFF
DIAGNOSTIC ON
ECHO ON
FILE ?
INITIAL ?
INSPECT OFF
SHOW [ / OUT list-file / ] TERM