Pathway/iTS System Management Manual (G06.24+)

TERM Commands
HP NonStop Pathway/iTS System Management Manual—426748-002
10-31
STATS TERM Command
COUNT number
specifies the number of times that the STATS command repeats. You can stop the
repeating of the command by pressing the Break key.
FREQTABLE
generates a frequency distribution table containing statistics for each terminal. The
frequency distribution table is not generatedeven if you specify the FREQTABLE
optionunder the following conditions:
•
There have been fewer than 50 response time measurements collected at the
time of the STATS request.
•
At the fiftieth measurement, the size of the time interval calculated is less than
0.01 second.
For more information about the FREQTABLE option, including a sample display,
see Section 5, Tuning Your System Using Statistics.
INTERVAL number
specifies the time period between the statistics displays, incremented in hours,
minutes, or seconds.
RESET
sets the counters used for the measurements back to zero.
TERM *
displays statistics for all TERM objects described in the PATHMON configuration
file. If option is specified, displays statistics for all TERM objects meeting the
criteria specified.
STATE state-type
specifies the state of the multiple TERM objects. Possible values are:
RUNNING NOT RUNNING
STOPPED NOT STOPPED
SUSPENDED NOT SUSPENDED
This command displays statistics only for those TERM objects in the RUNNING or
SUSPENDED state. If you specify any other state, the system redisplays the
command prompt; it does not display any output or generate an error message.
You can substitute SEL for STATE.
TCP tcp-name
displays statistics for all TERM objects controlled by the specified TCP.