Pathway/iTS System Management Manual (G06.24+)

HP NonStop Pathway/iTS System Management Manual—426748-002
11-1
11 PROGRAM Commands
This section describes the PATHCOM commands that define and control PROGRAM
objects; the commands are listed in alphabetical order. The PROGRAM commands are
as follows:
These commands define and control templates used by the PATHMON process when
creating temporary TERM objects in response to a RUN PROGRAM command. The
templates define tasks that enable TCPs to run screen programs temporarily on one or
more devices. With these commands you can do the following:
•
Set and modify PROGRAM attributes
•
Add and delete PROGRAM templates
•
Run the initial screen program defined in the PROGRAM template and add and
start a temporary TERM object
•
Display PROGRAM attributes
To Perform the Following Tasks… Use These PATHCOM Commands…
Define and remove PROGRAM objects SET PROGRAM
ADD PROGRAM
DELETE PROGRAM
Control PROGRAM objects RUN PROGRAM
Change PROGRAM object attributes ALTER PROGRAM
RESET PROGRAM
Obtain information about PROGRAM objects INFO PROGRAM
SHOW PROGRAM