Pathway/iTS System Management Manual (G06.24+)

PROGRAM Commands
HP NonStop Pathway/iTS System Management Manual—426748-002
11-8
RESET PROGRAM Command
RESET PROGRAM Command
Use the RESET PROGRAM command to change the values for the PROGRAM object
attributes (listed under program-keyword in the syntax) from the values that you
defined with the SET PROGRAM command to the defaults. This command does not
change the attributes of a PROGRAM object already added to the PATHMON
configuration file.
program-keyword
specifies one or more attributes to be reset.
If you omit tcp-keyword, this command resets all attribute values to the defaults.
Considerations
•
If you invoke the RESET PROGRAM command after the SET PROGRAM
command but before the ADD PROGRAM command, the attribute values you
specify revert to the default values.
•
Some required PROGRAM object attributes have no default values. If you include
a required attribute in the RESET PROGRAM command, the attribute is set to a
null value and must be set again before you add the PROGRAM object description
to the PATHMON configuration file.
If an attribute is not required and does not have a default value, the RESET
PROGRAM command deletes the value for the attribute.
•
If you set multiple values for an attribute (for example, the TYPE attribute), the
RESET PROGRAM command deletes all the values set for the attribute.
Examples
The following command resets all attribute values:
RESET PROGRAM
RESET PROGRAM [ program-keyword [ , program-keyword ]... ]
program-keyword is:
ERROR-ABORT
OWNER
PRINTER
SECURITY
TCP
TMF
TYPE program-type