Pathway/iTS System Management Manual (G06.24+)

PROGRAM Commands
HP NonStop Pathway/iTS System Management Manual—426748-002
11-24
SHOW PROGRAM Command
SHOW PROGRAM Command
Use the SHOW PROGRAM command to display a subset of the PROGRAM object
attributes in alphabetic order. This command displays the attribute values for a
PROGRAM object not yet added to the PATHMON configuration file.
OUT list-file
directs output to the named list file; this could be a DEFINE name. If this option is
omitted, the PATHMON process directs the output to the PATHCOM list file; this is
typically the home terminal.
Considerations
•
When PATHCOM first starts and after a RESET PROGRAM command executes,
the SHOW PROGRAM command displays only the required PROGRAM object
attributes and a subset of the optional attributes that have default values. A
question mark appears for the required attribute values that you must set before
adding the PROGRAM object.
•
SHOW PROGRAM displays all of the attribute values that you explicitly set with
the SET PROGRAM command.
•
For attributes that include Guardian operating environment file names, SHOW
PROGRAM displays the node-name part of the file name as either \nodename or
\*. The \nodename form is used if the node was explicitly specified by the user.
The \* form is used if the attribute was specified to default to the node where the
PATHMON process is running.
•
After an ADD PROGRAM command, the SHOW PROGRAM command continues
to display the attribute values held in PATHCOM for the previously added
PROGRAM object. Use the RESET PROGRAM command to change all of the
values to their defaults, or use the SET PROGRAM command to replace specific
attribute values.
Example
If you issue the SHOW PROGRAM command before setting the PROGRAM object
attributes, the following information is displayed:
PROGRAM
ERROR-ABORT ON
OWNER \TS.8,8
SECURITY "N"
TCP ?
TMF ON
TYPE ?
SHOW [ / OUT list-file / ] PROGRAM