Pathway/iTS System Management Manual (G06.24+)

TCP Messages (Numbers 3000-3999)
HP NonStop Pathway/iTS System Management Manual—426748-002
13-7
TCP Messages
3012
Cause. A screen was referenced but is not displayed. The screen is identified by a
screen number; 0 corresponds to the first screen declared in the program source.
Effect. The operation fails.
Recovery. Isolate and correct the problem within the SCREEN COBOL program. For
instructions on how to locate the problem within the program, see General Information
on page 13-1.
3013
Cause. There was an attempt to display an overlay screen in more than one overlay
area at the same time.
Effect. The operation fails.
Recovery. Isolate and correct the problem within the SCREEN COBOL program. For
instructions on how to locate the problem within the program, see General Information
on page 13-1.
3014
Cause. The terminal control process (TCP) detected an invalid I/O protocol value or
an internal TS/MP or Pathway/iTS error occurred.
Effect. The operation fails.
Recovery. If an invalid I/O protocol value was detected, contact the application
programmer.
If an internal error occurred, contact your service provider and provide all relevant
information as follows:
•
Descriptions of the problem and accompanying symptoms
•
Details from the message(s) generated
•
Your PATHMON configuration file and PATHMON process version
•
A description of the application task that was in progress when the error was
encountered
*3012* TERM term-name, SCREEN REFERENCED BUT NOT DISPLAYED
(screen-number)
*3013* TERM term-name, OVERLAY SCREEN DISPLAYED IN TWO AREAS
*3014* TERM term-name, ILLEGAL TERMINAL IO PROTOCOL WORD