Pathway/iTS System Management Manual (G06.24+)

Configuration Limits and Defaults
HP NonStop Pathway/iTS System Management Manual—426748-002
C-2
Table C-2. Limits and Defaults for Parameters (page 1 of 6)
PATHCOM
Parameter* SPI Token/Field** Value Limits and Defaults
AUTORESTART ZAUTORESTART Values: 0 through 32,767
Value should be greater than 0.
Default: 0
BACKUPCPU ZCPU
ZCPUPAIR
Values: 0 through 15
Value should be a CPU that is not
physically adjacent to the primary CPU.
Default: Depends on command
BREAK ZBREAK Values: ON | OFF
Default: OFF
CHECK-DIRECTORY ZCHECKDIRECTORY Values: ON | OFF
Suggested value is OFF for production,
ON for development.
Default: ON
CODEAREALEN ZCODEAREALEN Values: 0 through 2,147,483,647 bytes
Use SCUP (SCREEN COBOL Utility
Program) or
STATS TCP to determine this value.
Default: 65,536
COUNT N.A. Values: 0 through 65,536
Default: 1
DEBUG ZDEBUG Values: ON | OFF
Default: OFF
DIAGNOSTIC ZDIAGNOSTIC Values: ON | OFF
Default: ON
DISPLAY
-PAGES
ZDISPLAYPAGES Terminal Type Minimum Maximum Default
T16-6540 1 16 (1) 7
T16-6530WP 1 8 (1) 7
T16-6530 1 (2) 8 (1) 7
T16-6520 1 (2) 3 3
IBM-3270 1 1 1
TS530 1 8 (1) 8
Note (1):This is the absolute maximum allowed in the
TCP. However, if the terminal or terminal emulator
has less memory, the working value is negotiated
downward.
Note (2):Although the PATHMON process allows you
to set the number of pages to 1, some terminals or
terminal emulators do not allow that setting. For
example, the T16-6520 terminal always sets its
number of display pages to 3, regardless of the user
setting.
* PATHCOM is the interactive management interface.
** SPI is the DSM management programming interface.