Pathway/XM System Management Manual

PXMCFG Messages
Compaq NonStop™ Pathway/XM System Management Manual—426761-001
12-12
6844
Cause. The SET TCP NODE statement was not specified. The NODE attribute is
required to evaluate swap file-name references.
Effect. The PXMCFG process does not generate a SuperCTL file.
Recovery. Enter a SET TCP NODE statement.
6845
Cause. The object name has already been defined in the configuration.
Effect. The PXMCFG process does not generate a SuperCTL file.
Recovery. Specify a unique name for the object.
6846
Effect. The PXMCFG process generates this warning message when the number of
TCPs configured per PATHMON process is ten or lower.
Cause. No effect; this is an informational message only.
Recovery. No recovery required. To increase the ratio of TCPs per PATHMON
processes, modify the TCP weights.
6847
Effect. The PXMCFG process has determined that a PATHMON process must execute
on a system for which you have not yet defined a NODE object.
Effect. The PXMCFG process does not generate a SuperCTL file.
Recovery. Enter a SET PATHMON NODES statement to add the system named in the
message. If you have not yet defined this system as a NODE object, you must first enter
a SET NODE statement to define it.
*6844* THE CLIENT NODE ATTRIBUTE MUST BE DEFINED BEFORE THE
CLIENT ATTRIBUTE CAN BE PROCESSED
*6845* ENTRY ALREADY EXISTS object name
*6846* NUMBER OF TCPS CALCULATED FOR EACH PATHMON IS
LOW: number-tcps-per-pathmon
*6847* PATHMON NAME NOT FOUND FOR MACHINE: system-name