Pathway/XM System Management Manual

PXMCOM, PB, and LCS Messages
Compaq NonStop™ Pathway/XM System Management Manual—426761-001
13-16
PXMCOM Messages (Messages 6500-6799)
Effect. The command fails.
Recovery. Determine the problem from the error information in the message, correct it,
and retry the command.
6517
Cause. The PXMCOM process was unable to assign the physical node specified in the
SuperCTL file for a well-known, named PATHMON process. This message is usually
preceded by message 6519 and may indicated a corrupted SuperCTL file.
Effect. The specified well-known, named PATHMON process is not created.
Recovery. You may need to reload the SuperCtl file to eliminate any corrupt data.
6518
Cause. The PXMCOM process cannot determine the state of the Pathway/XM
environment. Some PATHMON processes may be in a state other than what is
registered in the SuperCTL file.
Effect. The command fails.
Recovery. Use the STOP PATHWAY command, then restart Pathway/XM.
6519
Cause. The SuperCTL file cannot be locked.
Effect. The START PATHWAY command fails.
Recovery. Determine the problem from the error information in the message.
6520
Cause. The PXMCOM process encountered an error when attempting to read the
NODE object’s configuration information stored in the SuperCTL file.
Effect. The command fails.
*6517* Unable to assign node-name to PATHMON name
*6518* This Pathway system has indeterminate state. Please
STOP PATHWAY and restart it.
*6519* Error Locking SuperCTL file: error-number
*6520* Failure reading NODE node-name from SuperCTL file.
Error=error-number