Pathway/XM System Management Manual

PXMCOM, PB, and LCS Messages
Compaq NonStop™ Pathway/XM System Management Manual—426761-001
13-43
PXMCOM Messages (Messages 6500-6799)
Recovery. Check that the parameter name was entered correctly and, if not, reissue the
command. If the parameter name was correct, then the parameter must be added
through a new Pathway/XM configuration.
6672
Cause. The define name specified is not associated with the identified server class. The
CONTROL SERVER DEFINE command can only be used to alter a define that was
originally configured through PXMCFG.
Effect. The command fails.
Recovery. Check that the define name was entered correctly and, if not, reissue the
command. If the define name was correct, then the define must be added through a new
Pathway/XM configuration.
6673
Cause. The SuperCTL file is in an invalid state. This error is often generated with
other error messages when errors are encountered during execution of a START
PATHWAY command.
Effect. The command fails.
Recovery. Issue a STOP PATHWAY command to place the SuperCTL file back into a
consistent state. Stop any orphaned processes associated with the Pathway/XM
environment. Reissue the START PATHWAY command. If problem persists, recreate
the SuperCTL file.
6674
Cause. The STOP PATHWAY command was issued for a NODE object that is not
active.
Effect. None.
Recovery. Informational message only; no corrective action is needed.
*6672* Invalid ‘CONTROL SERVER DEFINE’, previously not
declared
*6673* NODE (node-name) has already been started
*6674* NODE (node-name) already stopped