PEEK Reference Manual

PEEK Syntax and Examples
PEEK Reference Manual — 529657-006
2 - 24
Elements of the INTERRUPTS Display
OTHER IPS AND
APS
Number of dispatches for IPs and APs such as General Fault
Handler (GFH), TimeList IP, Send Queued Messages AP,
Signal Trap Monitor AP, and XRAY IP that do what was
considered an Interrupt Handler before the H-series RVUs.
CPU Busy Time for IPS and APs such as General Fault
Handler (GFH), TimeList IP, Send Queued Messages AP,
Signal Trap Monitor AP, and XRAY IP, which perform the
functions that an Interrupt Handler performed before the H-
series RVUs.
IDLE Number of dispatches and CPU Busy Time for idle process.
TNET Header identifying interrupts for TNet Services IPs.
EXCEPTION Number of TNet Services Error interrupts such as AVT errors,
link errors, TNet st
ack errors
, errors from other processes such
as the message system, storage, and so on.
IPC Number of message interprocessor communication (IPC)
interrupts.
COMM Number
of COMM I/O interrupts.
STORAGE Number of STORAGE I/O interrupts.
X1 Number of interrupts on TNet Services X-fabric.
Y1 Number of interrupts on TNet Services Y-fabric.
INTERRUPTS Header identifying other interrupts, traps, and events.
(Note: The elements mentioned under the INTERRUPTS
display are a
pplicable only for H-series R
VUs and J-series
RVUs.)
TIME Number of time-list interrupts.
SIGNALS Number of entries to the signal or trap monitor.
MEASURE Number of measure processh event
s.
INTERFACE LIMIT Nu
mber of interface limit-exceeded traps.
STACK OVERFLOW Number of stack overflow traps.
ARITH OVERFLOW Number of arithmetic overflow traps.
INTERUCTION FAIL Number of instruction failure traps.
ILLEGAL ADDRESS Number of illegal-address reference traps.
INST BREAKPOINT Number of instruction breakpoint interrupts.
MAB BREAKPOINT
Number of memory-access breakpoint interrupts.
Table 2-3. INTERRUPTS Elements Reported in the INTERRUPTS
Display (page 2 of 2)
Element Description
1
1
For definitions of the different types of interrupts and traps reported by the INTERRUPTS option, see the
Glossary
.