Processor Halt Codes Manual

%000027
Cause
An unexpected interrupt or trap occurred during a load operation.
Effect
The processor halts. The rest of the system is not affected.
Recovery
contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000030
Cause
A condition code less than zero (CCL) was returned from an execute input/output (EIO) command.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000034
Cause
A sector checksum error occurred during a disk read operation.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000035
Cause
A tape read failed after ten retries of “backspace and reread.”
Effect
The processor halts. The rest of the system is not affected.
Recovery
Clean the tape drive and remount the tape. If the error recurs, contact your service provider or
the Global NonStop Solution Center (GNSC), as directed by your local operating procedures.
%000036
Cause
The system-image tape (SIT) used for the tape boot has an erroneous structure.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Check the tape; if it is not the correct SIT, load the correct tape. If the error persists, contact your
service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%000037
100 Software Halt Code Descriptions