Processor Halt Codes Manual

Cause
An interrupt timeout occurred and the device is not responding.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000040
Cause
The disk bootstrap loader could not verify the processor millicode.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). After taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%000044
Cause
The system-image file is invalid because it is either corrupt or in the process of being purged.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Recreate a new system-image file and retry the load operation.
%000045
Cause
The subvolume specified for the system-image file did not contain a system-image file.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Verify that the correct system-image file is restored to the location designated for it. Retry the
operation.
%000047
Cause
Not enough physical memory was available to load the specified system-image file.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Add more physical memory or choose another system-image file.
%000051
Standard Processor Halt Code Descriptions 101