Processor Halt Codes Manual

Cause
No disk millicode could be found on the system-image tape (SIT) for downloading the system-load
disk controller.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000053
Cause
The processor image found in the system-image file was for a different processor type or a
different processor number.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Verify the system-generation process to ensure that the correct processor type and number have
been specified, then retry the load operation.
%000054
Cause
The number of the processor being loaded was not found in the system-image file.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Check that you specified the correct processor number. Verify the system-generation process to
ensure that the processor number is specified in the system-image file., then retry the load
operation.
%000055
Cause
During the tapeboot-to-diskboot system-load sequence, the tape boot failed to pass control to
the disk boot.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Retry the tape boot system-load operation by loading from a correct system-image tape (SIT).
You can also install a disk bootstrap with the Subsystem Control Facility (SCF) command
CONTROL DISK. If the error persists, refer to Processor Halt Monitoring and Recovery (page 10).
After taking a memory dump, contact your service provider or the Global NonStop Solution
Center (GNSC), as directed by your local operating procedures.
%000056
Cause
The disk volume label does not contain a section for the disk directory or disk bootstrap.
Effect
The processor halts. The rest of the system is not affected.
102 Software Halt Code Descriptions