Processor Halt Codes Manual

Recovery
There are two possible recovery procedures for this halt code:
• Choose another disk from which to load.
• If the error persists, load the system from a system-image tape (SIT). Loading the system from
a SIT is the last resort, because it erases the disk to which the tape is copied. Before
performing this operation, contact your service provider or the Global NonStop Solution
Center (GNSC), as directed by your local operating procedures.
%000057
Cause
An incorrect response packet was received from the disk controller.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). After taking a memory dump, contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%000060
Cause
The bootstrap tried to read beyond the end of the file.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000061
Cause
A checksum error was detected during a data read from tape.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000062
Cause
Consistency checks against the disk volume label failed.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000063
Standard Processor Halt Code Descriptions 103