Processor Halt Codes Manual

Cause
Disk space was not large enough to load all of the system-image files during tape boot.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000076
Cause
The version of the programmable read-only memory (PROM) code is too low to be compatible
with the bootstraps.
Effect
The processor remains halted. The rest of the system is not affected.
Recovery
Replace the PROM code with the correct version and reexecute the load operation.
%000102
Cause
An attempt was made to load a processor from a tape or disk that does not contain the bootstrap
code for that system. This error is generated by programmable read-only memory (PROM), which
is responsible for reading the bootstrap code from the tape or disk containing the system-image
file.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Retry the operation, specifying the correct tape or disk.
%000104
Cause
A breakpoint was encountered during a tape load operation. Breakpoints are used only by
software development.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000105
Cause
A breakpoint was encountered during a disk load operation. Breakpoints are used only by
software development.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
106 Software Halt Code Descriptions