Processor Halt Codes Manual

%000120
Cause
The primary or secondary extent of a file is bad or is zero.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000121
Cause
The tape or disk boot work area is corrupted.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000122
Cause
The SYSDISC file was not found on the system-image tape (SIT).
Effect
The processor halts. The rest of the system is not affected.
Recovery
Regenerate the SIT, making sure that the SYSDISC file is on the tape. If retrying the operation
fails, contact your service provider or the Global NonStop Solution Center (GNSC), as directed
by your local operating procedures.
%000123
Cause
A bad checksum was detected on a file label.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000124
Cause
A WRITE command packet is longer than the maximum length of 1024 bytes.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000125
Standard Processor Halt Code Descriptions 107