Processor Halt Codes Manual

Cause
A breakpoint was encountered during a disk boot operation. Breakpoints are used only by
software development.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000201
Cause
PROMBoot has detected that the ServerNet addressable controller (SAC) controller chip is not
initialized.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000202
Cause
PROMBoot has detected that the ServerNet addressable controller (SAC) controller chip is not
online.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000203
Cause
PROMBoot has detected that the PROMBoot SCSI routine failed to allocate a buffer for I/O
operations, because either access validation and translation (AVT) is not available or the processor
cache invalidation failed.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000204
Cause
PROMBoot has detected that the block transfer engine (BTE) is not able to send a packet through
ServerNet.
Effect
The processor halts. The rest of the system is not affected.
Standard Processor Halt Code Descriptions 109