Processor Halt Codes Manual

Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000205
Cause
PROMBoot has detected that the timeout period expired during a SCSI operation without receiving
any acknowledgment from the controller.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000206
Cause
An unexpected I/O interrupt packet was received by PROMBoot.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000207
Cause
The SCSI status returned by a device was not consistent with the CHECK CONDITION.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000210
Cause
The disk read operation was returned with a CHECK CONDITION in SCSI status, indicating
that the read was only partially completed.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%000211
Cause
PROMBoot has detected that an I/O packet whose entry type is COMMAND type has been
received because the previous command packet was rejected.
110 Software Halt Code Descriptions