Processor Halt Codes Manual

Effect
The processor halts. The rest of the system is not affected.
Recovery
If an instruction failed, contact your service provider or the Global NonStop Solution Center
(GNSC), as directed by your local operating procedures. To put the new bootstraps onto the
system disk, load the system from a tape that has the new operating system, or use the Subsystem
Control Facility (SCF) command CONTROL DISK.
CAUTION: Before loading the system from tape, contact your service provider or the Global
NonStop Solution Center (GNSC), as directed by your local operating procedures. The tape
load procedure results in a loss of all files on the disk.
%001002
Cause
An error occurred in the processor when a processor reload was attempted.
Effect
The reload operation failed. The rest of the system is not affected.
Recovery
Retry the reload operation. If the operation fails, refer to Processor Halt Monitoring and Recovery
(page 10).
%001004
Cause
There were inconsistencies in operating system data structures set up by the bootstraps.
Effect
The system freezes.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%001005
Cause
Inconsistencies occurred in operating system data structures during a system-load or system-reload
operation, and the processor type is unknown.
Effect
The system freezes.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%001007
Cause
An error was found during the DISPATCH procedure.
Effect
All freeze-enabled processors halt.
118 Software Halt Code Descriptions