Processor Halt Codes Manual

Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Before attempting a memory dump,
contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%001010
Cause
A bad processor PMAP (an internal data structure) was found.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Before attempting a memory dump,
contact your service provider or the Global NonStop Solution Center (GNSC), as directed by
your local operating procedures.
%001012
Cause
Inconsistencies in operating system data structures were detected during process dispatch.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%001016
Cause
The processor encountered too many non-fabric-specific ServerNet errors beyond the threshold
specified.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%001017
Cause
During processor initialization, the system was unable to allocate sufficient memory to monitor
ServerNet errors and statistics.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%001020
Standard Processor Halt Code Descriptions 119