Processor Halt Codes Manual

Cause
The CPU being reloaded is not supported.
Effect
The CPU being reloaded halts.
Recovery
The CPU processor type is not supported in the system. This can occur, for example, if an
NB50000c blade is inserted in an NB54000c system (i.e., a system whose coldload CPU is an
NB54000c).
%002001
Cause
The monitor was unable to lock the stack after the system was loaded.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%002002
Cause
The system-image file failed to open after the system was loaded. There are two possible reasons:
• The disk booted from was inconsistent with its mirror drive and the mirror has been
determined to be more up-to-date.
• The system disk was incorrectly labeled; its permanent name must be $SYSTEM.
Effect
The processor freezes.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%002003
Cause
A NEWPROCESS error occurred on initial loading of the command interpreter.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%002011
Cause
An internal logic error was detected while the external cluster was being reset.
Effect
The processor halts. The rest of the system is not affected.
122 Software Halt Code Descriptions