Processor Halt Codes Manual

service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%002025
Cause
The monitor is unable to obtain the physical path corresponding to $SYSTEM. (You might be
loading from a disk other than the one you specified in the system generation process.)
Effect
The processor halts. The rest of the system is not affected.
Recovery
Verify that the disk from which you are loading the system is labeled with the same name that
you specified in the system-generation process. If the halt recurs, refer to Processor Halt Monitoring
and Recovery (page 10). Take a memory dump and contact your service provider or the Global
NonStop Solution Center (GNSC), as directed by your local operating procedures.
%002026
Cause
Due to an internal problem in the monitor process, a page fault occurred while the monitor
process was opening the system-image file.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%002027
Cause
A DP2 tailpin process terminated abnormally.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%002030
Cause
A DP2 tailpin process terminated without first leaving its process group.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%002400 through %002417
Standard Processor Halt Code Descriptions 125