Processor Halt Codes Manual

Cause
A LOCKTLE timed out with no corresponding LOCKWAITLIST entry.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Take a memory dump of the affected processor, collect the required information, and contact
the Tandem NonStop Support Center (TNSC).
%003006
Cause
A bad address was found in the LOCKWAITLIST entry.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Take a memory dump of the affected processor, collect the required information, and contact
the Tandem NonStop Support Center (TNSC).
%003007
Cause
A privileged software error occurred—a call to the SENDMEMORY procedure was attempted
from a nonresident segment.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%003010
Cause
A privileged software error occurred—a call on the RECEIVEMEMORY procedure was attempted
to a nonresident segment.
Effect
The processor halts. The rest of the system is not affected.
Recovery
Refer to Processor Halt Monitoring and Recovery (page 10). Take a memory dump and contact
your service provider or the Global NonStop Solution Center (GNSC), as directed by your local
operating procedures.
%003011
Cause
A privileged software error occurred—a wrong sender was detected in the RECEIVEMEMORY
procedure.
Effect
The processor halts. The rest of the system is not affected.
128 Software Halt Code Descriptions